WIRE, Distributor Primary, repro, from points to coil, includes boot to seal to distributor case, 8 7/8 inch out of distributor, .29 inch distributor wire hole, yellow boot & eyelet connector at coil, See 12216-2AK, 34656-S36 for mounting hardware options,
NPD Part Number : 12216-2A Manufacturer Reference #'s: 64-68 DIST, B8Q-12216-A, DW-4, C3AZ-12216-A, DW-20
1965-1966 MUSTANG 289 EXCL HIPO
1967-1967 COUGAR 289 ** USE 12216-9 **
1963-1966 FALCON 260, 289
1966-1966 FAIRLANE 289
1966-1966 BRONCO 289
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
good product, however a little short for the coil on the left hand side of the engine
Submitted on December 21, 2018 by Juerg W.
YES I would recommend this product.
Quality
Value
Submitted on February 12, 2019 by David E.
YES I would recommend this product.
Quality
Value
Doesn't fit my original 1968-289 distributor. Grommet is too small to properly seal the hole in the side of the distributor that the primary wire goes through. Otherwise, it's fine. I would recommend it with reservations. The hole in my distributor is 27/64" (0.42" dia) and the grommet dia is 0.30". I have to wrap tape around the tapered part of the grommet to make it seal.
Submitted on September 21, 2021 by Joseph M.
YES I would recommend this product.
Quality
Value
I wanted to edit my previous review of 3 stars and give this a 5 star rating. NPD contacted me after I said the wire grommet wouldn't fit my '68 289 distributor. Turns out there were 2 types of wire grommets and NPD forwarded me the proper wire and it fit perfectly!
Submitted on October 13, 2021 by Joseph M.
YES I would recommend this product.
Quality
Value
This fit perfectly on the distributor of my 1964 1/2 Mustang 289 and allowed my to reinstall points and condenser to troubleshoot an engine surging issue I thought the electronic kit was causing.
Submitted on April 01, 2023 by Richard B.
YES I would recommend this product.
Quality
Value
Looks a little different than the original. The rubber wire insulation at the distributer, is slightly different.
Submitted on September 16, 2023 by David C.
YES I would recommend this product.
Quality
Value
In Stock!
