Original style. (10). Black oxide finish. See 927-1 for a handy tool that can install these rivets with a little practice and patience or the much simpler tool found in the 21774-1A seal kit can work as well.
Ford Mustang Years:
1965 (65), 1966 (66)
Above years shown are used for searches and are not application listings.
NPD Part Number : 21450-1AK Manufacturer Reference #'s: National Parts Depot 21450-1AK, 351603-S
1965-1966 MUSTANG
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Submitted on August 19, 2020 by KATHY W.
YES I would recommend this product.
Quality
Value
These rivets are well made but by design are tiny and hard to install because of where they go on a vent window frame assembly. I have the (very expensive) special rivet tool but still have not been able to seat one of them successfully. I can't fault the rivet because of the difficult location they go in. I'm going to have to come up with a different fastener but that doesn't mean the rivet is at fault.
Submitted on November 05, 2021 by Juan S.
Quality
Value
Rivets are a tad delicate. As much as I tried everyone I installed split. Mostly due to not having the correct style tool. In hindsight I’d use 3M black weatherstrip adhesive along with the rivets.
Submitted on August 25, 2022 by Brian J.
YES I would recommend this product.
Quality
Value
The division bar weatherstrip rivets was delivered quickly. However, they were a little too short. It may be because I am using aftermarket parts that are not to spec as they probably should be. they appear to be the correct length when I compare them to the old drilled out rivets. i ended up using modified screws and panel bonding adhesive instead. I'm giving 5-stars for the service and product quality.
Submitted on May 16, 2024 by Baldomero D.
YES I would recommend this product.
Quality
Value
In Stock!
