VALANCE PANEL, Rear, improved repro, new tooling with better fit and thicker 1.2 mm steel vs 0.8 mm, dual exhaust, See 40544-5K, 40544-1BK, 375838-S, 40545-3K, 40545-1K, 40545-1BK, 40545-1CK, 40545-1DK, 40545-1AK for mounting hardware and license mounting options,
NPD Part Number : 40544-4B Manufacturer Reference #'s: FDM1016AH-DII, C7ZZ-6540544-B
1967-1968 MUSTANG DUAL EXHAUST
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Tiene un espesor muy bueno, ajustada perfectamente al automóvil, lo recomiendo bastante
Submitted on February 23, 2019 by Hernández M.
YES I would recommend this product.
Quality
Value
Part shipped damaged. Spot welded mounts were broken off in the box. This is supposed to be the upgraded Panel, would hate to see the cheaper one. Went directly to the Ventura store to exchange and was told they only do will calls, due to COVID 19 and is understandable, and that I would have to ship back and speak to a manager. If you are willing to do a will call, you could have easily just exchanged for a good one just the same. Decided to just go have the mounts spot welded back on than to deal with the headache of their unfriendly return policy.
Submitted on May 27, 2020 by Randall W.
Quality
Value
This was my second try at one that fits. I removed an OEM valance on a virgin car, because i wanted dual exhaust and GT quad exhaust tips. First one from another mustang warehouse that had listing for two, from different manufacturers. I picked the more expensive deluxe. Not even close to fitting. I am a retired auto body man. No way to make it fit. TOO SHORT. This one from NPD FIT ALMOST PERFECT. .
Submitted on September 30, 2020 by Henry S.
YES I would recommend this product.
Quality
Value
Although better than the previous versions, it still required some reshaping and trimming of the exhaust cutout area. Also the ends are not shaped correctly to fit against the rear quarters, and the right side was about a 1/4" too short to meet the rear quarter. Most of the work can be accomplished with a hammer and dolly, except for adding material the right end.
Submitted on November 06, 2021 by John P.
YES I would recommend this product.
Quality
Value
Submitted on February 03, 2022 by Al S.
YES I would recommend this product.
Quality
Value
In Stock!
