National Parts Depot
Search ...

SWAY BAR KIT, REAR


Full Description
(1)
Item # 5A772-9A
MPN # 5A772-9A
Brand: ADDCO

$249.46
Out of Stock




In Store Availability:
FL
NC
MI
CA
Description

SWAY BAR KIT, Rear, by Addco, 7/8 inch diameter, heavy duty custom bent black powdercoated bar, black polyurethane bushings with end links and frame brackets, mounting hardware and instructions are included when required, OE style, must be used if car originally had a rear bar, ADDCO anti-sway bars will cut body roll and increase cornering ability, Match a 1 front bar with a 3/4 rear bar and a 1 1/8 front bar with a rear 7/8 bar for the best match for neutral handling using stock springs, High carbon steel bars with forged rod ends ensure against deformation

NPD Part Number : 5A772-9A
Manufacturer Reference #'s: Addco K1-679-0U,

Vehicle Information

Year-Range (bold)      Model (bold)      Fits/Applications

1971-1973 MUSTANG W/O FACTORY REAR SWAY BAR

1971-1973 COUGAR W/O FACTORY REAR SWAY BAR

WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Reviews

5 Star Avg.
1 Review

100% of reviewers recommend this product.

Write a Review
Verified Buyer SWAY BAR KIT, REAR

Installed this on my '73 mustang. Noticed immediate handling improvement. "Feel" of the road increased. This rear bar along with quality shocks makes the car handle like something much lighter and responsive. Body roll cut down in corners and braking. Make sure you check the clearance for gas tank vent. I had to disconnect and re-route around bar as it positions close against the front of the tank where vent hose comes out and goes up. Bar is formed to stay out of wide tire area as it goes forward to spring anchors. In order to install as close to front of axle housing as possible (which they suggest), I removed the stock spring retainer and replaced with supplied parts. Installation took me about 2hrs + - and pretty straight forward. Fit & finish: powder coated black bar with high gloss finish. Balance of parts cad plated but not polished at all (punched) with black rubber (urathane?) Fit good without any modification necessary to metal parts on car or piece. Looks very nice from wheel well but again,clean but not show quality accessory parts. Does it's job well.

Submitted on February 11, 2019 by

YES I would recommend this product.

Quality

5 Stars

Value

5 Stars