“Ford Racing” logo. lue crinkle finish has raised logos. Die cast aluminum with a modern look.
13” diameter with 2 5/8” tall element. Sets come with mounting hardware including “Ford” logo die cast center nut. Note that 4” of hood clearance is required from the carburetor gasket area to the bottom of the hood. close hood slowly to confirm sufficient clearance visually.
See 380958-S, 370970-S, 358871-S, 370970-SAK, 9600-1AK, 9600-2AK, 9600-3AK, 9600-4AK, 9600-5AK, 9600-6AK 9600-8AK, 9600-9AK for mounting hardware options.
Not 50 state legal for all year, make, model and engine combinations.
This part is legal for sale or use only on non-emissions controlled vehicles or on vehicles where the part is considered a direct replacement for a factory installed part.
The following vehicles are considered non-emissions controlled vehicles:
•1965 and older U.S. manufactured California certified vehicles.
•1967 and older U.S. manufactured Federally certified vehicles.
•1967 and older Foreign manufactured vehicles.
It is against the law to install this part on an emissions controlled vehicle.
The following vehicles are considered emissions controlled vehicles:
•1966 and newer U.S. manufactured California certified vehicles.
•1968 and newer U.S. manufactured Federally certified vehicles.
•1968 and newer Foreign manufactured vehicles.
NPD Part Number : 9600-30B Manufacturer Reference #'s: 302-381,
0-0 FORD FITS FORD 2100, 4100 AND HOLLEY CARBS WITH 5 1/8” DIAMETER NECK
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Submitted on April 15, 2019 by Robert L.
YES I would recommend this product.
Quality
Value
In Stock!
