National Parts Depot
Search ...

Shaker Scoop Base to Hood Seal, w/o studs (glue-on design), GM Licensed repro


Full Description
Shaker Scoop Base to Hood Seal, w/o studs (glue-on design), GM Licensed repro
(1)
Item # C-3410-245B
MPN # C-3410-245B
Brand: GM Restoration Parts

$25.46
In Stock!




In Store Availability:
FL
NC
MI
CA
Description

SEAL, Shaker Scoop Base to Hood, w/o studs (glue-on design), GM Licensed reproduction

An accurate reproduction of the original glue-on shaker scoop to hood seal for 1977-1981 Pontiac Trans Am models. The shaker scoop to hood seals were originally glued in place by GM. Studs were not originally used on most production models, but were integrated by GM into service parts to facilitate a more durable installation (original seals could come unglued depending on weather / driving conditions), GM Licensed reproduction.

Restoration Note:

Glued in place seals are the concours-correct model for a perior-correct restoration. Studs were not originally used on most production models, but provide a more durable installation. See part number C-3410-246A for stud design seal.

Note:

Adhesive is not included; see our 3M weatherstrip choices: part numbers 3M8008, 3M8080 or 3M8090.

Pontiac Trans Am Years:

1977 (77), 1978 (78), 1979 (79), 1980 (80), 1981 (81)

National Parts Depot is a participant in the GM Restoration Parts license program. Products using this GM Restoration emblem are licensed products accepted in the GM licensing program. The GM Restoration Parts emblem/logo is a registered trademark of General Motors and used under license to National Parts Depot. Only products bearing the GM restoration emblem have been accepted into the program

Vehicle Information

Year-Range (bold)      Model (bold)      Fits/Applications

1977-1981 FIREBIRD W/O MOUNTING STUDS (GLUE-ON)

WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Reviews

4 Star Avg.
1 Review Write a Review
Verified Buyer Shaker Scoop Base to Hood Seal, w/o studs (glue-on design), GM Licensed repro

This product would be prefect, if it was a little bit longer. When you buy it, it never says it will not fit to the edge of the shaker scoop. When you get the gasket, you get a picture of a shaker scoop with this gasket and it shows it does not cover the entire edge of the shaker scoop. Buyer beware

Submitted on December 28, 2023 by

NPD - National Parts Depot

The notion that the seal should cover the entire edge of the shaker is false and incorrect. The picture of the shaker that we provide is of a 1979 Trans Am with only 77 original miles from new (see installation instructions linked on this page to see photo and instructions). The seal, and its orientation/relationship to the edge of the shaker, is precisely as-assembled by Pontiac at the factory. 

Our seal is developed to perfectly replicate the original factory fit, and we provide the photo so that restorers can replicate original and do it right. 

So I hope this information gives you a bit more satisfaction with the seal. It is correct. Gluing a seal to run flush with the outer edge of the shaker would be incorrect.

Quality

1 Star

Value

1 Star