Repro. Each. Canadian made, 16 gauge. The fit of these to a floor pan has been excellent.
Ford Mustang Years:
1965 (65), 1966 (66), 1967 (67), 1968 (68)
Above years shown are used for searches and are not application listings.
NPD Part Number : 132-1LH Manufacturer Reference #'s: M132L, C5ZZ-6510672-A
1965-1968 MUSTANG COUPE, FASTBACK, LH
1967-1968 COUGAR LH, ORIGINAL PART WAS 1 INCH SHORTER THAN THIS REPRO, TRIM AS REQD
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Put this in my 67 Mustang Coupe after replacing the floorpan. The overall quality of the product is great. The metal is as thick or thicker than the original. The fit was pretty good. Did take a little work to get the side tabs to fit but it was easy enough. I am a novice so if I say it was easy then for someone with experience it would be nothing. Out of the box, it did have a bit of a twist to it. A little heat with some weight on it and it all straightened out.
Submitted on October 16, 2020 by Charles C.
YES I would recommend this product.
Quality
Value
Thick gauge material, but way too tall on one end. had to do heavy trimming and refabricating mount tab to correct the height.
Submitted on February 03, 2021 by Robert B.
Quality
Value
I purchased these Canadian Made, thicker steel seat risers pre-pandemic for my '66 coupe, so I am uncertain of the possible "change in tooling" as noted in product description. The risers I received were virtually identical to the factory risers -- perhaps better! These seat platforms lined up perfectly with the concours correct, U.S. Made, thicker steel floor pan that again, was purchased pre-pandemic.
Submitted on August 29, 2022 by Blaine W.
YES I would recommend this product.
Quality
Value
In Stock!
