REPAIR PANEL, Firewall, lower floor extension, RH, aka toe board, Canadian made, Outer flange is bent down when it should be bent upward, .035 inch thick steel or 21 gauge, Note: While these panels are made in Canada and at one time part of the Paddock/American-Designers tooling, the quality of the parts have degraded over time to a point where we have a strong preference towards their imported counterpart,
NPD Part Number : 126-1RH Manufacturer Reference #'s: M126R,
1965-1968 MUSTANG TRIM TO FIT 69-70
1967-1968 COUGAR TRIM TO FIT 69-70
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Hopeless pressing shape where the item meets the tunnel on the car.
Submitted on June 17, 2019 by David M.
Quality
Value
Besides having rust spots on it the size of a dime to a quarter, it fit well.
Submitted on July 04, 2019 by Stephen S.
YES I would recommend this product.
Quality
Value
These toe boards go higher up on the firewall than what might be necessary so trimming will definitely need to be done. The right side has a flange that points down, so if you're installing with a torque box it will need to be trimmed off. The flange on the torque box points up, so these two would interfere with each other. It's a quick trim and will fit nicely once it's done. I installed this after cutting out the old toe board and left a slight overlap, about an inch and welded both sides to seal it up. I then applied seam sealer along those welds.
Submitted on March 25, 2020 by Christopher T.
YES I would recommend this product.
Quality
Value
quality material. worked excellent
Submitted on July 31, 2020 by Paul D.
YES I would recommend this product.
Quality
Value
Doesn’t fit well at all. Required extensive trimming and bending to make it fit.
Submitted on February 06, 2021 by David P.
Quality
Value
good piece
Submitted on May 12, 2021 by Robert C.
YES I would recommend this product.
Quality
Value
This Canadian Made thicker piece worked nicely with the US Made, thicker steel floor pan in my '66 coupe. I only needed the lower section of the Toe Board, so some cutting was involved. I purchased this item in early 2020, so I am uncertain about any "tooling issues," as mentioned on this site.
Submitted on September 04, 2022 by Blaine W.
YES I would recommend this product.
Quality
Value
In Stock!
