Rear. Original style mohair material glues into channel. Does both sides. Not quite as wide as the original but wide enough to fit inside the track with careful planning and placement. Many installers will need to order 2 kits to complete the project as the correct positioning of the material is key to proper coverage using just one kit. Gluing with HLG-1 or 3M8001 is required.
Ford Mustang Years:
1965 (65), 1966 (66)
Above years shown are used for searches and are not application listings.
NPD Part Number : 21508-1B Manufacturer Reference #'s: National Parts Depot 21508-1B,
1965-1966 MUSTANG
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Perfect replacement for OE material for door run bars. I was able to just cut out the worn fabric and replace it with the new one. Easy repair with the door run bar out of the door.
Submitted on March 16, 2019 by Phil S.
YES I would recommend this product.
Quality
Value
By accident, I ordered two packages of this material. It's a good thing I did, because the material is not wide enough to cover the entire channel. I began by overlapping on the outer edge as the factory did, and the material only made it part way up the next side. I wound up putting another piece from there up and over that side. It works, but it would have been better if it was wider and could have been done in one piece. Order two packages, or you won't be able to cover the entire guide. The material is good, it's the width of it that is the problem.
Submitted on December 19, 2019 by Marty T.
YES I would recommend this product.
Quality
Value
I needed two kits. A little wider piece and it would have been easy to get by with one kit.
Submitted on November 14, 2022 by James J.
YES I would recommend this product.
Quality
Value
In Stock!
