Repro. Correct shape for dual exhaust cars. Welds to rear floor on the LH side. There is a raised “L” shaped protrusion where this bracket would be located. Bracket has the correct “D” shaped locator hole for the brake hose. Can be used to replace an existing bracket or to convert single exhaust to dual. Ford relocated the brake hose to keep it away from the LH exhaust pipe.
Ford Mustang Years:
1965 (65), 1966 (66)
Above years shown are used for searches and are not application listings.
NPD Part Number : 2A051-1A Manufacturer Reference #'s: ST2A051,
1965-1966 MUSTANG DUAL EXHAUST
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Good fit had to trim off a little bit of panel to make it perfect and its heavy enough gauge metal to get a good weld to the original floor plan.
Submitted on February 01, 2021 by Alexander K.
YES I would recommend this product.
Quality
Value
Submitted on April 15, 2022 by Michael K.
YES I would recommend this product.
Quality
Value
Had to open the hole
Submitted on October 21, 2023 by Glenn
Quality
Value
This L Bracket was not shaped to the correct angle/configuration. Had to place it in a vice and hammer it to the proper angle. However the material, the size and the hole for the rubber brake hose to fit into position correctly were all spot on.
Submitted on October 23, 2023 by William S.
YES I would recommend this product.
Quality
Value
In Stock!
