Custom clear anodized aluminum, satin finish. Architectural grade process resists fading. .063 aluminum. Fills the gap between the top of the grille and radiator support forcing more air to flow through the radiator.
** Note: On factory A/C cars this panel interferes with the upper dryer tube. To install, a clearance notch will need to be made. **
** Note: These are primarily located by the radiator support mounted hood bumpers. We have found that the location of the factory mounts can vary enough where the holes in this shield may not line up perfectly. You may need to elongate the holes and use an oversize washer to correct this factory variance. **
Ford Mustang Years:
1969 (69), 1970 (70)
Above years shown are used for searches and are not application listings.
NPD Part Number : 8C291-4B Manufacturer Reference #'s: 69MU-00C,
1969-1969 MUSTANG MODIFY FOR FACTORY A/C
1970-1970 MUSTANG
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Just a heads up on this product. First of all. the sheet metal is on the thin side. Second, You have to relocate both horns to make it fit. Don't know why this wasn't mentioned in the first place and no info how too. Would have been great if the shield was cut to clear the horn bracket in the first place. Good thing I have a Dremer. Still a decent product but over $150.00, you shouldn't have to modify it!
Submitted on September 29, 2019 by Daniel Q.
Quality
Value
Had to make one small cut. Changes the look of the engine bay 100% MACH 1 owners, this is a must have !
Submitted on November 02, 2024 by Mark Y.
YES I would recommend this product.
Quality
Value
In Stock!