QUARTER REPAIR PANEL, Lower Rear, RH, Canadian made, 12 inch tall, .035 inch thick steel or 21 gauge
NPD Part Number : 100-2RH Manufacturer Reference #'s: M100AR,
1965-1966 MUSTANG RH
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Good quality needed a little more fitting but 10 times easier than trying to use patches.
Submitted on May 05, 2019 by Fred G.
YES I would recommend this product.
Quality
Value
Nice thick metal but the bends are radiused where the original Ford panels are clean crisp 90 bends. Makes fitment difficult without lots of hammer work to get the shape correct. If you are using the whole piece it would work (although not technically look 100% correct) but I was just needed a portion of it and there was no way it was going to Fit up against the original metal without serious work. I ended up buying a full quarter and cutting out the piece I needed. It had much more correct bends.
Submitted on October 02, 2020 by David C.
Quality
Value
This worked for me since I replaced a small portion where it folded over the rear fuel filler panel. I had to fabricate the portion that folded on that panel since the repair panel did not have that molded in. The lower portion that meets the rear trunk kick down panel did not have as crisp bends as the original panel. So if you need to replace that portion, it will look really bad.
Submitted on October 05, 2020 by James F.
Quality
Value
THERE ARE NO HOLES FOR THE DRAIN ON THE BOTTOM OR THE REAR TAIL PANEL.ALSO NOT PRIMED.
Submitted on April 02, 2021 by vincent p.
YES I would recommend this product.
Quality
Value
Submitted on March 30, 2022 by Michel G.
YES I would recommend this product.
Quality
Value
Great fit fast shipping
Submitted on April 14, 2022 by RBR e.
YES I would recommend this product.
Quality
Value
Submitted on October 25, 2024 by Brad M.
Quality
Value
In Stock!
