All internal seals and wipers replaced. Power Steering Control Valves are thoroughly cleaned and exterior surfaces reconditioned for like-new look. Each component is carefully inspected and replaced if not to OE tolerances. All seals and O-rings are replaced with OE equivalent parts. Each unit is tested and balanced to ensure OE performance. Ball joints are properly lubricated. Painted with a high quality paint. All units are carefully packaged to ensure safe arrival at your door. Remanufactured in the USA and backed with a Limited Lifetime Manufacturers Warranty. This valve has been properly lubricated at the factory...do not add grease!
**You must flush the PS system anytime components are replaced to eliminate any contamination and to validate manufacturers warranties. Many transmission fluids available on the market do not meet manufacturer minimum standards for friction, viscosity, corrosion or wear, In fact Cardone, the largest supplier of rebuilt power steering components, has found the cause of many power steering related failures can be traced back to low quality fluid, Dont risk your restoration on a budget brand fluid. See 19582-2 for Motorcraft brand Type F fluid for use in vehicles that specify type F in the P/S system up to 1995. **
Ford Thunderbird Years:
1955 (55), 1956 (56)
Above years shown are used for searches and are not application listings.
NPD Part Number : T-3A730-1A Manufacturer Reference #'s: 1,
Product Instructions and Additional Info:
Rebuilt Power Steering Control Valve Instruction1955-1956 TBIRD
1955-1956 TBIRD
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Very nice rebuilt unit.
Submitted on June 23, 2022 by Fred A.
Quality
Value
I was unhappy that the threads on the ball stud were damaged, by whoever previously removed this control valve from their vehicle. The rebuilder (Lares) should have checked the condition of the threads to make sure that a nut could be screwed onto them. It took me about 2 hours, working with a file to restore the threads to a condition that would allow me to thread the nut back on them. Not acceptable for the price paid. Lares needs to improve their quality checks.
Submitted on June 17, 2023 by Dale A.
YES I would recommend this product.
Quality
Value
In Stock!