Repro. With 141 front extension. 60.25 visible side length. 16 gauge. Note the 141 front extensions included are 5 shorter than the originals. The length difference is not visible and is between the inner and outer rocker panel skin. See 141-1LH for correct length front extensions.
Ford Mustang and Shelby Years:
1967 (67), 1968 (68), 1969 (69), 1970 (70)
Above years shown are used for searches and are not application listings.
NPD Part Number : 010129-2E Manufacturer Reference #'s: FDM1030DL-DII,
1967-1970 MUSTANG LH, COUPE, FASTBACK
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Good construction but it needed to be fitted for a 69 convertible. It was 5/8" too wide so it had to be re-cut lengthwise.
Submitted on August 10, 2017 by Patrick B.
Does not fit 69/70 without a LOT of mods. Holes are wrong for everything. Because of the way it installs, it is VERY difficult to make accurate measurements to ensure fit. If you are going to use this on a 69/70 be VERY cautious on your cuts so you can splice it in properly.
Submitted on April 01, 2018 by Eric N.
Things haven’t improved over the past few years. The rocker is still about 1/2” too wide and extends about that distance beyond the quarter panel on my 67 fastback. It requires taking out about 1/2” of material in the sill channel to make it fit properly. I haven’t attempted to make it fit, but the best option might be to form a jig and hammer out the sill channel so it becomes deeper and narrower.
Submitted on February 18, 2021 by Bill K.
Quality
Value
All the frame parts arrived and were perfect for the job - 70 Mustang Convertible....
Submitted on July 04, 2022 by Thomas K.
YES I would recommend this product.
Quality
Value
In Stock!