MONTE CARLO BAR, straight, black painted, good repro, The Monte Carlo bar was originally added to the Monte Carlo raced Falcons and later the 1964 Monte Carlo Mustangs to further reinforce the shock towers by triangulating the support in conjunction with the one piece export brace, The bar keeps the shock towers from collapsing inward and keeps camber adjustments more consistent, When you install this bar you may notice that the bar will not fit in between the aprons, This is due to the shock tower and aprons flexing inward, It may be necessary to spread the shock towers outward to fit the brace and return the towers to their original designed position, Make sure to check your front end alignment after installation, Each side bracket has 4 mounting holes, 3 of which are existing holes, 40 7/16 inch between brackets, .08” plate thickness including coating, 1” O.D. tube with 1.2mm tubing wall thickness, 2.0 lb actual weight, See 29432-1AK for mounting hardware option,
NPD Part Number : 29432-1A Manufacturer Reference #'s: FFE64Z004Q, S1MS-29432-A
1965-1966 MUSTANG 8 CYL.
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The bar is a little too wide for my engine compartment, but with as old as the car is, and the wide tolerances that they were built to, this is understandable. I'll try spreading the shock towers a bit, and if that doesn't work, then I'll shorten the bar.
Submitted on September 07, 2018 by Marty T.
YES I would recommend this product.
Quality
Value
In Stock!
