MONTE CARLO BAR, curved, black painted, good repro, Originally curved to clear the Shelby oval air cleaner the curved version also provides convenient clearance to the distributor cap simplifying maintenance chores, The Monte Carlo bar was originally added to the Monte Carlo raced Falcons and later the 1964 Monte Carlo Mustangs to further reinforce the shock towers by triangulating the support in conjunction with the one piece export brace, The bar keeps the shock towers from collapsing inward and keeps camber adjustments more consistent, When you install this bar you may notice that the bar will not fit in between the aprons, This is due to the shock tower and aprons flexing inward, It may be necessary to spread the shock towers outward to fit the brace and return the towers to their original designed position, Make sure to check your front end alignment after installation, Each side bracket has 4 mounting holes, 3 of which are existing holes, 40 1/2 inch between brackets, .080 inch plate thickness including coating, 1inch O.D. tube with 1.2mm tubing wall thickness, 2.0 lb actual weight, See 29432-1AK for mounting hardware option,
NPD Part Number : 29432-2A Manufacturer Reference #'s: FFE64Z005Q,
1965-1966 MUSTANG 8 CYL.
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The part fit into my Mustang without any issues and works as expected.
Submitted on July 22, 2018 by Dan M.
Quality
Value
Bought this in anticipation of dropping it right in. Turns out it was 1/2 inch too long. Having the means I cut it down and welded it to fit. Other’s would just send it back.
Submitted on September 02, 2019 by alvie s.
Quality
Value
I had installed a straight Monte Carlo bar a few years ago and it was sturdy and well made. However, removing the distributor was to much hassle with it so I decided to replace it with the straight bar. The new curved bar is really flimsy and in fact one of the connectors was bent. NPD was good about sending a replacement but it is such a piece of junk I'm not sure it is worth installing.
Submitted on April 30, 2020 by Mike B.
Quality
Value
Did not fit well, had to heavily modify and repaint
Submitted on September 17, 2020 by Steve R.
YES I would recommend this product.
Quality
Value
Mounting holes did not line up on my car , very lightweght. Wish i had ordered the heavier one.
Submitted on January 23, 2024 by William D.
Quality
Value
Submitted on March 16, 2024 by Masami K.
YES I would recommend this product.
Quality
Value
In Stock!
