MOLDING SET, Rear Window, repro, 4 piece set, See 42413-2AK,03148-3CK, 03148-3EK, 03149-2K, 03148-3K, 42413-1K, 03148-2K, 03149-5K, 42413-2K for mounting hardware options,
NPD Part Number : 42400-1B Manufacturer Reference #'s: FFE64D207Q,
1965-1966 MUSTANG FASTBACK
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
This trim was absolutely horrible and fit horrible, they should not have wasted the stainless. Top pieces were 1/2 shorter than original so they did not meet up in the middle of the window leaving a huge gap. This trim is also 1/4 slimmer than the original so it barely touches the window rubber. The curve on the lower pieces also do not match up so there is a gap between the quarter and the trim. Its like whoever made this part never put it on a car. They just said this looks close here you go. I would pay 3 to 4 x more for something that fit.
Submitted on April 26, 2019 by Gregory C.
Gregory,
I laid these moldings over original Ford moldings on a 1966 fastback in our collection, and I did not find any of the dimensional anomalies that you described. Each molding adequately reaches the other (no gaps), and no 1/4" slimmer that I can see. I was, however, concerned by the contour of the RH lower molding, and questioned whether it could be fastened in place for a good fit. As such, I am going to have the manufacturer do a test install a.s.a.p.. Rick, NPD
Quality
Value
The curvature of the side and bottom pieces did not match the curvature of the window but with some effort was able to make them align.the top pieces together are shorter than the top of the window, barely touching (no overlap) and leaving a 1/4” gap at the top of the molding.
Submitted on November 04, 2019 by Mike K.
Quality
Value
These moldings fit way better than I expected and have read about. Take your time and install they will work.
Submitted on February 09, 2021 by Travis P.
YES I would recommend this product.
Quality
Value
This trim does not fit well at all. The top pieces are shorter by about 1/4" over the originals I had leaving a gap at the top. The corner radius is also not very well done but can be made to work. Do not buy these.
Submitted on April 11, 2021 by Jeff W.
Quality
Value
The part looks good but was bent in the box I notified in PD but still have not received a reply.
Submitted on January 16, 2023 by joe c.
YES I would recommend this product.
Quality
Value
Works, fits, good quality
Submitted on September 25, 2024 by Rodrigo V.
YES I would recommend this product.
Quality
Value
In Stock!
