Repro. Steel cap. Has proper flange for TBird to clear the hood cable. A VERY close reproduction of the original.
Ford Thunderbird Years:
1955 (55), 1956 (56), 1957 (57)
Above years shown are used for searches and are not application listings.
NPD Part Number : T-2140-1A Manufacturer Reference #'s: MCM-18567, B5A-2140-B
1955-1957 TBIRD
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
I was please with the fit and operation of this new master cylinder for my '57 Tbird.
Submitted on March 21, 2020 by Brian W.
YES I would recommend this product.
Quality
Value
As received, this item could not be used as the piston bore was not machined properly. The bore was only machined about half way, thus the plastic tip on the pushrod became stuck at the end of the machined portion, thus the pushrod from the pedal could not seat properly. The result eas a pedal with NO free travel that could barely move an inch. The master cylinder had to be rebuilt with a new piston before it could be used. Fortunately, NPD DID provide a rebuild kit when advised of the situation. Master Cylinder DOES work properly after having been rebuilt.
Submitted on April 30, 2021 by Michael C.
YES I would recommend this product.
Quality
Value
Submitted on May 22, 2021 by Frank V.
YES I would recommend this product.
Quality
Value
Submitted on September 28, 2021 by john f.
YES I would recommend this product.
Quality
Value
Submitted on October 30, 2021 by Ron B.
YES I would recommend this product.
Quality
Value
Submitted on March 09, 2022 by Cathy &.
Quality
Value
I was impressed with the quality of the Master Cylinder. I would highly recommend this product.
Submitted on January 05, 2023 by Timothy R.
YES I would recommend this product.
Quality
Value
Master Cylinder is in and works properly, although the Bore for the plunger is tapered and was undersize for the plastic end of the brake push rod. Had to grind about 0.020" off the plastic plunger OD.
Submitted on November 13, 2024 by Leo W.
YES I would recommend this product.
Quality
Value
In Stock!