Repro. OE style with riveted ball joint, press in bushing and jack plated installed. Half black painted with silver painted ball joint end to replicate the originals dipped look. This arm uses an original dimension bushing and will accept aftermarket bushings in either rubber or polyurethane.
See 3078-1K, 34033-S18, 72053-S8 for mounting hardware options.
Ford Mustang Years:
1965 (65), 1966 (66),
Above years shown are used for searches and are not application listings.
Ford Falcon and Ranchero Years:
1962 (62), 1963 (63), 1964 (64), 1965 (65)
Above years shown are used for searches and are not application listings.
NPD Part Number : 3078-1A Manufacturer Reference #'s: C4DZ-3078-A, C4DZ-3078-A
1965-1966 MUSTANG
1962-1965 FALCON (FROM 10/15/61)
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Not a good product. The arm slides on the sleeve of the bushing. The ball joint leaks grease in between the joint and the control. A waste of money, save it and get tubular. I went went with Global West lowers and uppers.
Submitted on November 16, 2014 by Brian B.
Look good
Submitted on October 22, 2018 by Danny H.
YES I would recommend this product.
Quality
Value
rock solid! fits perfect. super tight
Submitted on November 09, 2020 by Paul I.
YES I would recommend this product.
Quality
Value
Submitted on January 02, 2021 by Hugo H.
YES I would recommend this product.
Quality
Value
Good product however the nuts that came with it were not fine thread and could not use them. Luckily I was able to use the old ones
Submitted on January 24, 2021 by michael d.
YES I would recommend this product.
Quality
Value
Much better product than the ones from CJ Pony, that were back ordered, and NPD’s were less expensive
Submitted on March 02, 2021 by ROSS B.
Quality
Value
Very nicely made and fit very well. The only thing I noticed was that the holes where the strut rod attaches were slightly different sizes between the two that I ordered. The attach bolts fit into one of them, but not quite into the other. I just enlarged them a little with no problem.
Submitted on March 19, 2021 by Kenneth L.
YES I would recommend this product.
Quality
Value
Submitted on October 04, 2022 by thomas m.
YES I would recommend this product.
Quality
Value
Purchased for 1965 mustang fastback. Fit as intended.
Submitted on April 05, 2023 by Guillermo A.
YES I would recommend this product.
Quality
Value
In Stock!
