INSULATOR, Coil Spring, polyurethane, each, 2 required, Raises car approximately 1 inch, Do not use with stock height springs! Only use with 1 inch lowering springs, Use when 1 inch lowering springs are used with negative camber wedge kit that already lower the car somewhat and the sum total is too much for you to bare,
NPD Part Number : 5415-2B Manufacturer Reference #'s: Prothane U-60732-BL,
1965-1973 MUSTANG
1967-1973 COUGAR
1964-1970 FALCON (BEFORE 1/1/70)
1970-1970 FALCON (FROM 1/1/70)
1968-1971 TORINO
1966-1971 FAIRLANE
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
I had 1" drop springs on my 67 mustang, after doing the shelby drop, the car was too low. These helped get my car back up to a respectable height.
Submitted on May 25, 2019 by Dan W.
YES I would recommend this product.
Quality
Value
Two issues when installing two of these on my 70 Cougar XR7. First, the ID is about 1/16" too small to slide over the collar at the spring tower. Had to use a drum sander to open it up. Secondly, it is advertised as a 1" lift the actual measure is 13/16". Otherwise, all was well. Hopefully, it will hold up better than the 3/8" lift insulator I put in 4 years ago which had turned gummy and extruded out.
Submitted on January 05, 2021 by Thomas J.
YES I would recommend this product.
Quality
Value
I installed these units to raise my the front of my 65 Mustang. Installed as advertised. No problems related to the install
Submitted on September 21, 2023 by Eric R.
YES I would recommend this product.
Quality
Value
In Stock!
