Professional Grade Replacement. Improved* replacement style. One piece unit.
See 3350-2K, 3350-1K, 3350-3K for mounting hardware options.
Ford Mustang and Shelby Years:
1967 (67), 1968 (68), 1969 (69), 1970 (70)
Above years shown are used for searches and are not application listings.
Mercury Cougar Years:
1967 (67), 1968 (68), 1969 (69), 1970 (70)
Above years shown are used for searches and are not application listings.
NPD Part Number : 3350-1 Manufacturer Reference #'s: 18686, C7ZZ-3350-A
1967-1970 MUSTANG P/S
1967-1970 COUGAR P/S
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Submitted on September 15, 2018 by Don B.
Quality
Value
One foam dust boot is long enough for one end of the bushing but the other foam dust boot wasn’t long enough for the other end of the bushing. No installation instructions. Not sure if bolt that goes thru the bushing is supposed to be torqued against the bushing or if proper installation is to allow bolt to freely move/rotate inside the bushing sleeve. Frustrating.
Submitted on August 23, 2019 by Savvas R.
Quality
Value
No instructions, did not work. will go back to stock design with poly bushings
Submitted on December 24, 2019 by Don M.
Quality
Value
Perfect fit for original. One dust protector foam disk may be too small but my original was missing or not OEM. Tried to replace just the bushing but it was a nightmare to remove and then I damaged the new one trying to install it on the arm. Turns out I ordered the wrong size bushing - my bad, but in the end learned that replacing the whole arm is the way to go. No instructions needed if you know what an idle arm is and where it goes.
Submitted on March 03, 2021 by putt p.
YES I would recommend this product.
Quality
Value
Submitted on May 28, 2023 by John A.
YES I would recommend this product.
Quality
Value
In Stock!
