Imported. Trim rocker side edge for convertible. Correct part with proper ribs. 21 gauge.
Ford Mustang and Shelby Years:
1971 (71), 1972 (72), 1973 (73)
Above years shown are used for searches and are not application listings.
Mercury Cougar Years:
1971 (71), 1972 (72), 1973 (73)
Above years shown are used for searches and are not application listings.
NPD Part Number : 407-8-1RH Manufacturer Reference #'s: FDM1043JR,
1971-1973 MUSTANG RH, MODIFY SLIGHTLY FOR CONVERTIBLE
1971-1973 COUGAR RH, MODIFY SLIGHTLY FOR CONVERTIBLE
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Pan assembly did not come with drain plug. However I called national parts depot and they sent two out one for each side
Submitted on September 10, 2022 by Rick G.
YES I would recommend this product.
Quality
Value
Fits OK. Might need to trim a little here and there to get a good butt weld. This should be expected. If you just place this pan into the floor with overlap seams, fits well. Wish the panel extended a little farther under the rear seat. If this is rusty, plan on adding additional sheet steel to extend the floor pan under this area.
Submitted on August 25, 2023 by Leslie A.
YES I would recommend this product.
Quality
Value
In Stock!