FUEL LINE, Tank to Pump, carbon steel, 3/8 inch diameter, 2 pc, See 9369-3K, 9369-4K for apron grommet and 380374-S for fuel line clip options, By Classic Tube, All required flared fitting ends are SAE grade double flared, Lines are CNC bent in either carbon steel or in stainless steel for improved durability or show, Tubing is US-made SAE J526 spec. Carbon tubing has a galvanized type top coating that simulates the original Terne coating, ASTM B117 salt spray test is 3000 hours where originals only passed 250 hours, Concours approved, Stainless steel lines have an S at the end of the part number suffix for easy identification, In regards to the coating applied to carbon steel lines:The original Tinned Bundy Weld "TBW" tubing was originally manufactured by supplier Bundy Corporation, had a corrosion resistant coating called Terne coating, Unfortunately that top coating is no longer available because of a ruling outlawing the lead and tin dip process by the EPA almost 20 years ago, At the end of that time Bundy Corp. was moving that coating process to two of their other plants until finally the enforcement pushed them to comply, At that time Bundy Corp. had already switched to offering a few different aluminum rich coatings that was then the new OEM standard, In the end Classic Tube was successful in sourcing tubing made in the USA that is SAE J 526 specification and has a "galvanized" type top coating that simulates the original Terne coating, You may also be interested in knowing the results of the ASTM B117 salt spray test was only 250 hours for the old Terne coating, This tubing has passed at 3000 hours, Classic Tube does not useAluminized tubing, Zinc plated or the Off-Shore tubingthat the other manufacturers use and have the finishes that people dislike,
NPD Part Number : 9369-31A Manufacturer Reference #'s: Classic Tube MUF1012-OE,
1971-1973 MUSTANG 8 CYL.
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The short line needed only a few tweaks to fit. The long line had several areas where 90 degree bends were about 70 degrees. the tank end would be okay for a single exhaust car but was wrong for duals and needed a lot of rework.
Submitted on September 23, 2019 by Carl J.
YES I would recommend this product.
Quality
Value
Good quality but keep in mind that it will probably need a bit of tweaking here and there for the final fit.
Submitted on October 20, 2019 by Chris S.
Quality
Value
Very unimpressed. Required lots of rework to make work. Still have yet to hear back from anyone at NPD.
Submitted on October 05, 2021 by michael s.
Quality
Value
It actually fit like a glove. The lines matched the originals exactly.
Submitted on October 19, 2021 by Tom
Quality
Value
In Stock!
