FRAME RAIL, Rear, repair section, RH, 28 inch long from crossmember forward, Canadian made, .055 inch thick steel or 17 gauge, See also 103-1ARH, Note: While these panels are made in Canada and at one time part of the Paddock/American-Designers tooling, the quality of the parts have degraded over time to a point where we have a strong preference towards their imported counterpart,
NPD Part Number : 103-1RH Manufacturer Reference #'s: M103AR,
1965-1970 MUSTANG RH
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Fit perfectly. Cut, grind, clamp, measure twice and weld.
Submitted on July 07, 2020 by Kimberly S.
Quality
Value
Complete waste of money. Too heavy to send back. I threw it into the scrap metal pile in the shop and fabricated my own repair piece. Bends are not even close to factory, inner structure not as original, much weaker piece, bushing housing was welded in crooked. Complete garbage. NPD should not sell it without a disclaimer.
Submitted on January 20, 2021 by David D.
Quality
Value
Excellent product. Pay more attention then I did. This part is not meant to be butt welded. I cut my old one off before realizing this was meant to slide into the old rail. Oh well. It still worked after banging out the crimping.
Submitted on May 10, 2021 by Jon D.
YES I would recommend this product.
Quality
Value
Only needed the rear portion (roughly 18') of this rail, so outside of the faint seam where I had to cut & weld, this item is a perfect match. High quality material.
Submitted on December 19, 2021 by Blaine W.
YES I would recommend this product.
Quality
Value
In Stock!
