SOUNDPROOFING SET, Floor, (7) includes pre-cut pieces, reproduction
Note:
The smooth side installs face down (towards the floor pan), the rough side face up. The manufacturer does not recommend using adhesive to install, as the heat the floor pans get from climate, exhaust and transmission will help promote adhesion.
1967-1969 CAMARO
1967-1969 FIREBIRD
0-0 ** SMOOTH SIDE INSTALLS FACE DOWN (TOWARDS FLOOR PAN),
0-0 ROUGH SIDE FACE UP, MANUFACTURER DOES NOT RECOMMEND USING
0-0 ADHESIVE TO INSTALL, HEAT THE FLOOR PANS GET FROM CLIMATE,
0-0 EXHAUST AND TRANSMISSION WILL HELP PROMOTE ADHESION **
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The quality control is pretty bad; the inaccurate and vague instructions-which is nothing more than a poor illustration of the various pieces showing the incorrect location -didn't even indicate which side goes down. After trying to figure it out, it became obvious they were stamped so that all of the the smooth sides wouldn't face down, and the pieces had to be trimmed because the stamping hadn't fully cut the pieces. This is the third Repops product I have been disappointed with. Bought a set of the window felts and the q/c was terrible, but they did replace them and they were a little better. Bought a set of watershields and they were marginal too. I would expect these problems from a foreign manufacturer, not the US.
Submitted on September 23, 2018 by Chris M.
Quality
Value
In Stock!