FLOOR PAN, Short Front, LH, Canadian made, .035 inch thick steel or 21 gauge, Approximately 21 inch long, Note: While these panels are made in Canada and at one time part of the Paddock/American-Designers tooling, the quality of the parts have degraded over time to a point where we have a strong preference towards their imported counterpart,
NPD Part Number : 106-1LH Manufacturer Reference #'s: M106L,
1965-1973 MUSTANG LH, RIBBING MORE CORRECT FOR 65-68
1967-1973 COUGAR LH, RIBBING MORE CORRECT FOR 67-68
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Shipping cost was reasonable, but having bought floor pans from other suppliers, that were chinese made, I see no advantage for the extra few dollars spent. The chinese pans were also painted and not unprotected like the ones From NPD.
Submitted on February 08, 2019 by Thomas B.
YES I would recommend this product.
Quality
Value
Item as described, very quickly shipped.A+!
Submitted on March 27, 2019 by Michael G.
Quality
Value
Requires some cutting and fitting but is stated in description for 1970 applications. Good replacement.
Submitted on May 06, 2020 by Tim B.
YES I would recommend this product.
Quality
Value
Happy with purchase
Submitted on February 03, 2021 by Donald
YES I would recommend this product.
Quality
Value
Submitted on February 03, 2021 by Louis B.
YES I would recommend this product.
Quality
Value
The product arrived promptly and undamaged. I think it is typical for these panels that the flange that welds to the rocker bends down. The factory panels bend up. It works either way, but to look factory it takes a little rework. Oval hole is also a bit smaller and in a different spot. I do not care, but just an fyi.
Submitted on April 11, 2022 by Christopher R.
YES I would recommend this product.
Quality
Value
This part is a short drivers side patch panel for a 65 Mustang. Side flange was bent down instead of up, stamping was not the same as OEM panel I was replacing. I cut a small piece out of it and used it. I would not buy again.
Submitted on June 29, 2022 by Kevin U.
YES I would recommend this product.
Quality
Value
In Stock!
