FLOOR PAN, Rear Compartment / Trunk, Complete, Incl pre-punched drain holes, gas strap reinforcements, tail panel braces and staggered shock cutout locations, 47 3/4 inch front width, 61 1/4 inch rear width, 45 inch over all length, 21 gauge steel, EDP coated repro
1969-1969 CAMARO CONVERTIBLE AND COUPE
1969-1969 FIREBIRD CONVERTIBLE AND COUPE
0-0 ** 47 3/4 INCH FRONT WIDTH, 61 1/4 INCH REAR WIDTH, 45
0-0 INCH OVER ALL LENGTH, 21 GAUGE STEEL, EDP COATED REPRO **
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
A little more expensive than other places but clutch delivery. Holes for back bumper do not line up. These are the holes for the bolts that attache the bumper to the trunk floor rear brackets. After installed you have to drill the holes through to have proper alignment.
Submitted on June 13, 2021 by ANTONIO M.
YES I would recommend this product.
Quality
Value
Fit was excellent Thick gauge very heavy The 4 recessed ribs in the pan leading towards the rear axle are not exact so if your splicing I reccomend doing it above the ribs
Submitted on July 03, 2023 by chris c.
YES I would recommend this product.
Quality
Value
Trunk pan does not conform to frame rails. Not even close. Plan to spend extra time and $ to make this pan work.
Submitted on October 08, 2023 by Robert S.
Quality
Value
Note that this floor is really for a convertible. If you have a coupe the plates for the convertible trunk cans need to be removed and the holes filled. It is also missing one bracket on the bottom that was on the original floor, don't remember what bolted there. Will cut the original one off and install it on the new floor.
Submitted on December 09, 2024 by Marvin C.
YES I would recommend this product.
Quality
Value
In Stock!
"Truck Freight" Item.
