FLOOR PAN, Full Length, RH, Canadian made, rocker flange is bent upward, .035 inch thick steel or 21 gauge, Approximately 59 inch long, 19 gauge, Note: While these panels are made in Canada and at one time part of the Paddock/American-Designers tooling, the quality of the parts have degraded over time to a point where we have a strong preference towards their imported counterpart,
NPD Part Number : 107-8-1RH Manufacturer Reference #'s: M107-8AR,
1965-1970 MUSTANG COUPE, FASTBACK, RH, RIBBING MORE CORRECT FOR 65-68
1967-1970 COUGAR COUPE, RH, RIBBING MORE CORRECT FOR 67-68
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
very good stamping, only minor trim needed
Submitted on January 17, 2020 by Philip K.
YES I would recommend this product.
Quality
Value
Great product of high quality and fit.
Submitted on March 20, 2020 by Robert J.
YES I would recommend this product.
Quality
Value
Fit pretty good minimal modifications needed . Good quality
Submitted on May 07, 2020 by Daniel C.
YES I would recommend this product.
Quality
Value
Very nice piece. Trim as you need or replace complete.
Submitted on May 20, 2020 by Alan B.
Quality
Value
Good but the front extension up onto the firewall panel could be a little longer. (the 1/2 pan is about 3 inches longer) Had to patch a piece in on my 1970 where if it was the 1/2 pan length I would have been good to go.
Submitted on January 01, 2021 by John T.
YES I would recommend this product.
Quality
Value
Submitted on January 12, 2021 by Nicholas J.
YES I would recommend this product.
Quality
Value
Floor pan corner was bent when I got it.
Submitted on August 05, 2024 by Janice D.
YES I would recommend this product.
Quality
Value
In Stock!
