Repro. Primed. Outer flange is bent down when it should be bent upward.
Ford Mustang and Shelby Years:
1964 1/2 (64 1/2), 1965 (65), 1966 (66), 1967 (67), 1968 (68), 1969 (69), 1970 (70)
Above years shown are used for searches and are not application listings.
Mercury Cougar Years:
1967 (67), 1968 (68), 1969 (69), 1970 (70)
Above years shown are used for searches and are not application listings.
NPD Part Number : 126-1ALH Manufacturer Reference #'s: FDM1043WL,
1965-1970 MUSTANG TRIM TO FIT 69-70
1967-1970 COUGAR TRIM TO FIT 69-70
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Submitted on October 02, 2019 by Mark S.
YES I would recommend this product.
Quality
Value
Like it states trim to fit but don't let that scare you as it's a good thing. Only thing i could suggest is if one is replacing the front floor board is to make sure everything fits together like it should before welding in place. You could end up with the wrong conture coming off the transmission tunnel.
Submitted on November 17, 2019 by Robert M.
Quality
Value
Perfect fit. Great replacement part!
Submitted on May 06, 2020 by Tim B.
YES I would recommend this product.
Quality
Value
Submitted on April 11, 2021 by Joseph W.
Quality
Value
Poorly formed on the outer side that fits against the inner rocker panel.
Submitted on July 07, 2022 by William A.
Quality
Value
Good fit except for the outside edge had to be turned up instead of down to provide a welding surface with a torque box in place .
Submitted on September 12, 2022 by Jeff P.
YES I would recommend this product.
Quality
Value
Fit was nice I wish it would of been weld thru primer
Submitted on September 15, 2023 by Harry S.
YES I would recommend this product.
Quality
Value
In Stock!