DRAIN TROUGH, Trunk Lid Lower Corner, RH, good repro, Canadian made, Fits in the corner of the quarter panel and taillight panel, .035 inch thick steel or 21 gauge, Note: While these panels are made in Canada and at one time part of the Paddock/American-Designers tooling, the quality of the parts have degraded over time to a point where we have a strong preference towards their imported counterpart,
NPD Part Number : 142-1RH Manufacturer Reference #'s: M142R, C5ZZ-6545118-A
1965-1966 MUSTANG COUPE, CONVERTIBLE ONLY
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Did need a good bit of trimming.
Submitted on May 09, 2020 by Alan B.
YES I would recommend this product.
Quality
Value
Terrible fitting part. The shape meeting the taillight panel should be square and this is completely round. Does not fit the quarter either. Requires a lot of fabrication to get to work. I ended up grafting a part of the original to this one to make a little better. For the cost the quality is not there.
Submitted on September 22, 2023 by Erik v.
YES I would recommend this product.
Quality
Value
In Stock!
