DEFLECTOR, Dash Air Outlet, Side, chrome outer with black flaps, Repro
Note:
Rubber bushings / felt washers located at the top and bottom of these deflectors measure 5/8" thick. Some originals have measured at 7/8"-1" thick, thus the deflectors can be a little loose when installed in some models and may require re-using original washers.
Chevrolet Chevelle / El Camino / Malibu Years:
1971 (71), 1972 (72)
NPD Part Number : C-9262-105A Manufacturer Reference #'s: J-3270
1971-1972 CHEVELLE CHEVELLE, EL CAMINO AND MALIBU
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The quality of the vent is very nice. It appears to match up very well in form and construction as the original vents do. The only issue I ran into was with the white rubber bushing at the top and bottom. It was smaller (5/8 inch) versus the original (7/8) and thus when installed it wobbled around loosely. I had my original vents and just removed that bushing from them and put them on the new vents. I would assume a trip to any good hardware store could get you what you need as well although I would expect a product specific to make/model/year of my vehicle to have what was needed. overall good quality product though.
Submitted on June 12, 2015 by Pat P.
Submitted on September 11, 2018 by tony g.
YES I would recommend this product.
Quality
Value
Spacers were to small had to use ones off old vents ,Vent was good good fit.
Submitted on February 09, 2019 by michael d.
YES I would recommend this product.
Quality
Value
its nice part, except for the round felt spacer on each end. I read this in another review here, it is true. I used my old ones which were good. If the existing felt washer was bad i would have to send them back, or fabricate something. Unfortunately chinese
Submitted on April 16, 2019 by James C.
YES I would recommend this product.
Quality
Value
Fit nice and looks great.
Submitted on August 18, 2019 by Carlton A.
YES I would recommend this product.
Quality
Value
Pieces are a good replacement product for a daily driver. Suggestion would be to make the foam pieces at top and bottom a bit larger. Had to swap the old ones over to fit the housings better.
Submitted on April 13, 2020 by Santo C.
YES I would recommend this product.
Quality
Value
The nozzle is decent, but insulators are about 2/3 of the original ones size. If you use the the nozzle just flops around in the housing. Thankfully my old insulators were still useable.
Submitted on July 20, 2020 by kEVIN c.
YES I would recommend this product.
Quality
Value
Almost 5 stars except for the foam washers. They are under sized and give a very sloppy fit. I recommend reusing your old felt washers or making new felt ones like I did. The foam is junk.
Submitted on November 09, 2020 by Chad H.
YES I would recommend this product.
Quality
Value
Good product. The felt washers should be black and a little bigger in diameter.
Submitted on November 22, 2022 by mike s.
Quality
Value
In Stock!
