CYLINDER AND KEYS, Door Lock, bright finish, repro, pair, OE style round keys, includes 2 matched door locks and 2 dual sided standard keys, Remove pawls (levers) and replace with your originals, See 22050 for matching ignition and door lock sets, Must reuse original lock levers especially on trucks
NPD Part Number : 21984-2A Manufacturer Reference #'s: C5AZ-6221984-B, D2AZ-6521984-A
1967-1973 MUSTANG
1967-1973 COUGAR
1967-1979 F100-F350 TWO SIDED KEY, REVERSE LEVER FOR RH
1978-1979 BRONCO TWO SIDED KEY, REVERSE LEVER FOR RH
1966-1970 FALCON (BEFORE 1/1/70)
1970-1970 FALCON (FROM 1/1/70)
1968-1971 TORINO
1966-1970 FAIRLANE
1981-1985 F100-F350 (FROM 10/80), 2 KEY SYSTEM
1981-1985 BRONCO (FROM 10/80), 2 KEY SYSTEM
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Chrome is nice, fits well in the door, but the lever that connects to the lock actuating rod within the door has a fatal flaw. I'd attach a pic if I could, but where the lever rotates on the back of the lock cylinder, the level is missing pie shaped cut outs that allow the key to rotate all the way left or right and then re-center to remove the key. Thankfully I had my originals which I swapped on. If you buy these and do not have the originals to swap on you will not be able to lock or unlock your door via the key.
Submitted on November 10, 2020 by Sean D.
YES I would recommend this product.
Quality
Value
Completely worthless if you don't have your old locks. You must swap out the lever on the back of the lock with your old ones or these locks will not work at all. The ones that come with it do not rotate properly. You can see when you compare the old and new that they are not the same.
Submitted on March 13, 2021 by Mark W.
Quality
Value
Back part of lock did not match up what was on truck I removed piece and replaced with old one it’s an old truck someone probably used wrong lock in past np
Submitted on October 07, 2021 by Mark C.
YES I would recommend this product.
Quality
Value
Better than average quality but keep the levers off of your old locks for 78 F150
Submitted on April 13, 2023 by Elijah W.
YES I would recommend this product.
Quality
Value
As most others have already mentioned, the locks themselves are very well-made. However, the pawls or small attached levers that connect to the rods are of an incorrect length and cause the lock to malfunction, This can create a very serious problem of having your door permanently locked. It would not be rocket science to re-create the levers if you have the correct center to center dimensions. Hopefully Daniel Carpenter, or one of the other good reproduction companies will make them. I would advise the vendors to simply leave them off the locks so that people who don’t read instructions don’t create a serious problem for themselves.
Submitted on December 24, 2023 by John P.
YES I would recommend this product.
Quality
Value
Need to change out the actuating lever because the new one does not interface. Quick change over on the the bench. Seem like they will work well.
Submitted on June 22, 2024 by Jabe B.
YES I would recommend this product.
Quality
Value
In Stock!
