COVER, Grille Molding Lower Joint, best repro, includes sheet nut, Be careful installing the sheet nut on to the stud, The self threading aspect puts stress on the pin and over torquing can shear the pin, Pre-threading the nut off the car can help alleviate the potential problem, This situation also plagued original covers
NPD Part Number : 8221-2A Manufacturer Reference #'s: C7ZZ-8221-AR, C7ZZ-8221-A
1967-1968 MUSTANG
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The plastic pins separate from the cover. I’ve seen several broken ones at shows as well. I was able to use two of the special molding screws that also broke during installation. When the molding screw retainer breaks off you are left with an 8x32 perfectly flush head machine screw. Installed in the cover they allow you to clamp down much better and are nearly invisible after the part is painted.
Submitted on August 29, 2015 by Gretchen B.
Made out of plastic the pins that hold it in place break off the whole thing should be metal
Submitted on June 19, 2019 by Roger K.
Quality
Value
One of the pins twisted off while putting on fastener.
Submitted on August 26, 2019 by Robin M.
Quality
Value
Like everyone else, the 2 plastic pins broke off while installing it. I was able to use screws to finish the install.
Submitted on September 02, 2019 by Alejandro E.
Quality
Value
I am still waiting on receiving the back order of this item. Thank you!!
Submitted on September 12, 2019 by Michael C.
Quality
Value
Wish they had a better way of attaching this piece had to buy two as I broke the first on
Submitted on June 07, 2020 by Hardy B.
YES I would recommend this product.
Quality
Value
Great fit and finish.
Submitted on June 08, 2021 by Antonio H.
YES I would recommend this product.
Quality
Value
Submitted on June 28, 2021 by Robert G.
YES I would recommend this product.
Quality
Value
Submitted on June 28, 2021 by Robert G.
YES I would recommend this product.
Quality
Value
Not installed yet as I still need to get it painted but it looks great !!
Submitted on August 21, 2021 by William M.
YES I would recommend this product.
Quality
Value
Poor quality
Submitted on January 22, 2022 by Lucien M.
Quality
Value
Excellent quality and fit
Submitted on June 24, 2022 by Howard S.
Quality
Value
I had the same issue with the pins pulling away from the trim piece as others have described. I even made sure that I was holding them in place while trying to pre-thread the sheet nuts. I'm sure it can be done if you take extreme care and are patient with it. Otherwise, the finish looked good and it fit as expected.
Submitted on August 31, 2022 by Kris P.
Quality
Value
In Stock!