BUSHING SET, Clutch Release Rod, 3/8 inch I.D., pair in custom brass with cotter pins, used on rods with a round hole, These are not used on rods with the D shaped hole which would use wave washers instead of a bushing
NPD Part Number : 7526-1B Manufacturer Reference #'s: C0AZ-7526-A, C0AZ-7526-B
1965-1973 MUSTANG
1979-1979 MUSTANG M/T, CLUTCH PEDAL SHAFT
1967-1973 COUGAR
1960-1970 FALCON (BEFORE 1/1/70)
1966-1971 FAIRLANE FAIRLANE, TORINO, 70 1/2 FALCON
1961-1972 F100-F350
1966-1977 BRONCO
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The "hat" part of the brass bushing is thicker than the original nylon bushing. This prevents the end of the rod from pushing far enough to be able to put a cotter pin or spring clip - since the hole in the rod is obstructed. To solve the problem, I grinded or sanded off about 1 mm from the "hat" and then I was able to get the spring clip through the hole in the end of the rod.
Submitted on January 30, 2024 by Mike S.
YES I would recommend this product.
Quality
Value
Part fit perfect. Extremely fast shipping a always. Best place to buy parts.
Submitted on November 22, 2024 by Gregg P.
YES I would recommend this product.
Quality
Value
In Stock!