BRACKET SET, Door Window Channel, LH, 8 pieces of brackets and seals plus mounting hardware, Can be used for fresh installations or to install 70 style bolt in glass into a 69
NPD Part Number : 23289-3D Manufacturer Reference #'s: 3614GK,
1969-1970 MUSTANG (FROM 10/1/69), LH, BOLTED GLASS OR TO CONVERT TO BOLTED GLASS
1969-1970 COUGAR (FROM 10/1/69), LH, BOLTED GLASS OR TO CONVERT TO BOLTED GLASS
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The main brackets seemed a little warped and not contoured to the glass at the proper angle. The stud to hold the channel for the regulator roller arm hit the arm so had to cut stud off. The channel for the reg roller arm also is easily bendable. I squeezed it closed and after rolling window up and down a few times it just opened back up. I am buying an original part to replace as there is too much slack there. Gaskets were good. The studs for the guides barely gripped the pot metal and nearly stripped with moderate tightening. The guide inserts impressed me as there was no slack once on the guide rods. The window stop not quite as original, and will have to add more felt because it is not adequate to properly protect the window as it passes the stop going up and down in my opinion. If I had a 69 to 70 conversion to do again, I would source original parts.
Submitted on October 12, 2021 by David D.
YES I would recommend this product.
Quality
Value
In Stock!
