New. LH. Repro. 28 spline. 26 5/64 long. For use with stock width axle housing. No studs, use 1107-1.
Ford Mustang Years:
1965 (65), 1966 (66)
Above years shown are used for searches and are not application listings.
Ford Falcon and Ranchero Years:
1964 (64), 1965 (65)
Above years shown are used for searches and are not application listings.
Ford Fairlane and Ranchero Years:
1964 (64), 1965 (65)
Above years shown are used for searches and are not application listings.
NPD Part Number : 4235-2A Manufacturer Reference #'s: AX1-LH, C2OZ-4235-A, C5OZ-4235-A
1965-1966 MUSTANG LH, 8 INCH OR 9 INCH REAR AXLE WITH 28 SPLINES
1964-1965 FALCON LH, 8 INCH OR 9 INCH REAR AXLE WITH 28 SPLINES
1964-1965 FAIRLANE LH, 8 INCH OR 9 INCH REAR AXLE WITH 28 SPLINES
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Much stronger than the original.
Submitted on September 29, 2020 by Daniel F.
Quality
Value
Had bent axles and needed something straight. Car rides great now. Part was a perfect fit for my 66 Mustang with an 8" readend. NOTE: when installing the bearing, make sure to include the 1/4 inch spacer. Without it, your axle would be too deep by a quarter inch (not good). Cosmetically, it looks different from the original, but it also looks better machined as well. I also both the other side too, which was a good fit.
Submitted on July 09, 2023 by Eric E.
YES I would recommend this product.
Quality
Value
Good quality axle shaft, still had to trim it down a bit to fit as it was to long and not sure why as it had the spacer. But fit after trim and no more shaft noise.
Submitted on September 02, 2023 by Dan L.
YES I would recommend this product.
Quality
Value
In Stock!